3Com Baseline 2928 PWR Plus - Page 304

1-6
Figure 1-5 Configure a static route
Make the following configurations on the page:
z Type 1.1.2.0 for Destination IP Address.
z Select 24 (255.255.255.0) from the Mask drop-down list.
z Type 1.1.4.1 for Next Hop.
z Click Apply.
z Type 1.1.3.0 for Destination IP Address.
z Select 24 (255.255.255.0) from the Mask drop-down list.
z Type 1.1.5.6 for Next Hop.
z Click Apply.
# Configure a default route to Switch B on Switch C.
z After you log in to the Web interface of Switch C, select Network > IPv4 Routing from the
navigation tree and then click the Create tab to enter the page as shown in
Figure 1-6.