3Com Baseline 2928 PWR Plus - Page 320

2-8
Figure 2-9 Enable DHCP
z Click on the Enable radio button next to DHCP Service.
z Click Apply.
# Configure a DHCP server group.
z In the Server Group field, click Add and then perform the following operations, as shown in Figure
2-10.
Figure 2-10 Add a DHCP server group
z Type 1 for Server Group ID.
z Type 10.1.1.1 for IP Address.
z Click Apply.
# Enable the DHCP relay agent on VLAN-interface 1.