1-21
Configuration procedure
1) Configure the IP addresses of the interfaces. (Omitted)
2) Configure the RADIUS scheme system
# Configure the RADIUS authentication server.
z From the navigation tree, select Authentication > RADIUS. The RADIUS server configuration
page appears.
Figure 1-24 RADIUS authentication server configuration
Perform the following configurations as shown in
Figure 1-24.
z Select Authentication Server as the server type.
z Enter the primary server IP address 10.1.1.1.
z Enter the primary server UDP port number 1812.
z Select active as the primary server status.
z Click Apply.
# Configure the RADIUS accounting server.
Figure 1-25 RADIUS accounting server configuration
Perform the following configurations as shown in
Figure 1-25:
z Select Accounting Server as the server type.
z Enter the primary server IP address 10.1.1.2.
To Next Page
Loading...
