1-8
Figure 1-8 Configure a stack port on Switch A
z In the Port Settings area, select the check box before GigabitEthernet1/0/1.
z Click Enable.
2) Configure the slave devices
# On Switch B, configure local ports GigabitEthernet 1/0/2 connecting with switch A, GigabitEthernet
1/0/1 connecting with Switch C, and GigabitEthernet 1/0/3 connecting with Switch D as stack ports.
z Select IRF from the navigation tree of Switch B to enter the page of the Setup tab, and then
perform the following configurations, as shown in
Figure 1-9.
To Next Page
Loading...
