1-9
Figure 1-9 Configure stack ports on Switch B
z In the Port Settings area, select the check boxes before GigabitEthernet1/0/1,
GigabitEthernet1/0/2, and GigabitEthernet1/0/3.
z Click Enable.
Now, switch B becomes a slave device.
# On Switch C, configure local port GigabitEthernet 1/0/1 connecting with Switch B as a stack port.
z Select IRF from the navigation tree of Switch C to enter the page of the Setup tab, and then
perform the following configurations, as shown in
.
To Next Page
Loading...
