3Com Baseline 2928 PWR Plus - Page 52

1-10
Figure 1-10 Configure a stack port on Switch C
z In the Port Settings area, select the check box before GigabitEthernet1/0/1.
z Click Enable.
Now, Switch C becomes a slave device.
# On Switch D, configure local port GigabitEthernet 1/0/1 connecting with Switch B as a stack port.
z Select IRF from the navigation tree of Switch D to enter the page of the Setup tab, and then
perform the following configurations, as shown in
Figure 1-10.
z In the Port Settings area, select the check box before GigabitEthernet1/0/1.
z Click Enable.