ABB ACS880 - Page 173

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
1 = Adaptive program runningRunningb3
Reservedb4…13
ReservedState changingb14
1 = Error in adaptive programFaultedb15
1 = 10000h…FFFFh
- / real32
(Only visible with option +N8010 [application
programmability])
Displays the peak loading of the microprocessor caused
by the application program. This parameter can, for
example, be used to check the effect of a given application
program functionality on the CPU load.
The value is in percent of an internal quota.
Can be reset from the control panel by keeping Reset
depressed for over 3 seconds.
IEC application Cpu
usage peak
7.40
10 = 1 % / 10 = 1 %Peak microprocessor loading caused by application
program.
0.0 ... 100.0 %
- / real32
(Only visible with option +N8010 [application
programmability])
Displays the average loading of the microprocessor caused
by the application program. The value is in percent of an
internal quota.
IEC application Cpu
load average
7.41
10 = 1 % / 10 = 1 %Average microprocessor loading caused by application
program.
0.0 ... 100.0 %
- / uint16Displays the type of module detected in slot 1 of the drive
control unit.
Slot 1 option module7.51
0No module detected.No option
1Type of module detected.[module type]
- / uint16Displays the type of module detected in slot 2 of the drive
control unit.
Slot 2 option module7.52
0No module detected.No option
1Type of module detected.[module type]
- / uint16Displays the type of module detected in slot 3 of the drive
control unit.
Slot 3 option module7.53
0No module detected.No option
1Type of module detected.[module type]
0 / uint16Displays the FPGA logic version of module detected in slot
1 of the drive control unit.
The logic version is detected for DDCS option modules,
for example, FEN encoder modules (FEN-01, FEN-11,
FEN-21, FEN-31) and I/O modules (FIO-11, FDIO-01,
FAIO-01).
Slot 1 module logic
version
7.54
1 = 1Logic version of module detected in slot 1.0000…FFFFh
- / uint16Displays the software version of module detected in slot 1
of the drive control unit.
Slot 1 module
software version
7.55
Parameters 173