ABB ACS880 - Page 183

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
34
Bit 1 of 32.1 Supervision status (page 341).
Supervision 2
35
Bit 2 of 32.1 Supervision status (page 341).
Supervision 3
40
Bit 0 of 10.99 RO/DIO control word (page 181).
RO/DIO control word
bit0
41
Bit 1 of 10.99 RO/DIO control word (page 181).
RO/DIO control word
bit1
42
Bit 2 of 10.99 RO/DIO control word (page 181).
RO/DIO control word
bit2
43
Bit 8 of 10.99 RO/DIO control word (page 181).
RO/DIO control word
bit8
44
Bit 9 of 10.99 RO/DIO control word (page 181).
RO/DIO control word
bit9
See Terms and abbreviations (page 132).
Other [bit]
0.0 s / uint32Defines the activation delay for digital input/output DIO1
(when used as a digital output or digital input).
*DIO status
*Delayed
DIO status
t
On
t
Off
t
On
t
Off
1
0
0
1
Time
t
On
= 11.7 DIO1 ON delay
t
Off
= 11.8 DIO1 OFF delay
*Electrical status of DIO (in input mode) or status of
selected source (in output mode). Indicated by 11.1 DIO
status.
**Indicated by 11.2 DIO delayed status.
DIO1 ON delay11.7
10 = 1 s / 10 = 1 sActivation delay for DIO1.0.0 ... 3000.0 s
0.0 s / uint32Defines the deactivation delay for digital input/output DIO1
(when used as a digital output or digital input). See
parameter 11.7 DIO1 ON delay.
DIO1 OFF delay11.8
10 = 1 s / 10 = 1 sDeactivation delay for DIO1.0.0 ... 3000.0 s
Output / uint16Selects whether DIO2 is used as a digital output or input,
or a frequency output.
DIO2 function11.9
0DIO2 is used as a digital output.Output
1DIO2 is used as a digital input.Input
2DIO2 is used as a frequency output.Frequency
Running / uint32Selects a drive signal to be connected to digital input/output
DIO2 when parameter 11.9 DIO2 function is set to Output.
For the available selections, see parameter 11.6 DIO1
output source.
DIO2 output source11.10
Parameters 183