ABB ACS880 - Page 402

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Energy tariff 1 / uint32Selects (or defines a source that selects) which pre-defined
energy tariff is used.
0 = 45.12 Energy tariff 1
1 = 45.13 Energy tariff 2
Tariff selection45.14
00.Energy tariff 1
11.Energy tariff 2
2
Digital input DI1 (10.2 DI delayed status, bit 0).
DI1
3
Digital input DI2 (10.2 DI delayed status, bit 1).
DI2
4
Digital input DI3 (10.2 DI delayed status, bit 2).
DI3
5
Digital input DI4 (10.2 DI delayed status, bit 3).
DI4
6
Digital input DI5 (10.2 DI delayed status, bit 4).
DI5
7
Digital input DI6 (10.2 DI delayed status, bit 5).
DI6
10
Digital input/output DIO1 (11.2 DIO delayed status, bit 0).
DIO1
11
Digital input/output DIO2 (11.2 DIO delayed status, bit 1).
DIO2
See Terms and abbreviations (page 132).
Other [bit]
EUR / uint16Specifies the currency used for the savings calculations.Tariff currency unit45.17
101Euro.EUR
102Dollar.USD
100Local currency. The name of the currency can be edited
by choosing Menu - Settings - Edit texts on the control
panel.
Local currency
0.500 tn_MWh / uint16Defines a factor for conversion of saved energy into CO2
emissions (kg/kWh or tn/MWh).
CO2 conversion
factor
45.18
1 = 1 tn_MWh / 1000
= 1 tn_MWh
Factor for conversion of saved energy into CO
2
emissions.0.000 ... 65.535
tn_MWh
0.0 kW / real32Actual power that the motor absorbs when connected direct
on-line and operating the application. The value is used
for reference when energy savings are calculated.
Note: The accuracy of the energy savings calculation is
directly dependent on the accuracy of this value. If nothing
is entered here, then the nominal motor power is used by
the calculation, but that may inflate the energy savings
reported as many motors do not absorb nameplate power.
Comparison power45.19
- / -
Motor power. For scaling, see parameter 46.4.
0.0 ... 100000.0 kW
Done / uint16
Resets the savings counter parameters 45.1…45.9
Energy calculations
reset
45.21
0Reset not requested (normal operation), or reset complete.Done
1Reset the savings counter parameters. The value reverts
automatically to Done.
Reset
402 Parameters