Acre SPC42 - Page 186

To Next Page

To Previous Page

1. Select Configuration > Inputs > All Zones.

You can select Configuration > Inputs > X-Bus Zones to configure wired

zones only or Configuration > Inputs > Wireless Zones to configure

wireless zones only.

2. Configure the fields as described in the table below.

Zone The number is presented for reference and can not be programmed.

Description Enter a text (max. 16 characters) that serves to uniquely identify the zone.

Input The physical input is displayed for reference and is not programmable.

Type Select a type of zone from the drop down menu (see Zone types on

page278).

Area Only if (multiple) Areas is activated. Select an area to which the zone is

assigned from the drop down menu.

Calendar Select if necessary the desired calendar (see Calendars on page197).

For Security Grade 2/3 a calendar can be assigned only to zones of type

Exit Terminator, Technical, Key Arm, Shunt and X-Shunt. For Security

Grade Unrestricted a zone of any type can be associated with a calendar.

Attributes Click the Attributes button to display the Attributes page for the zone. Only

attributes that apply to that type of zone are displayed. See Zone

attributes on page283).

15.10.4.2 Adding/Editing an area

Prerequisite

Only if (multiple) Areas is activated.

1. Select Configuration > Areas > Areas.

2. Click Edit to edit an existing area.

3. Click Add to add a new area. If the Installation Type is Domestic or Commercial, an area is

automatically added and the Edit Area Settings page is displayed.

Tthe area type for the new area is automatically set to Standard.

If the Installation Type is Financial, the area must be added manually.

4. Enter a description for the new area and select an area type from one of the following:

- Standard – Suitable for most areas.

- ATM – Provides settings and defaults relevant to ATMs.

- Vault – Provides settings and defaults relevant to vaults.

- Advanced – Provides all area settings (Standard, ATM and Vault).

5. Click the Add button to add the area.

Configure the settings for each installation type as per the following sections.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023