Acre SPC42 - Page 193

Name Description
Zone
attributes
(Web only)
The attributes for the zone the door position sensor is assigned to can be modified.
Area
(Web only)
The area the zone and the card reader are assigned to. (If the card reader is used for setting
and unsetting, this area will be set/unset).
Door Position
(Web)
DPS End Of
Line
(keypads)
The resistor used with the door position sensor. Choose the used resistor value/combination.
DPS Normal
Open
Select if the door release switch is to be a normally open or normally closed input.
DPS Delay Specify a time (in seconds) for a delay to the DPS.
Door
Release
(Web)
DRS END
OF LINE
(Keypads)
The resistor used with the door release switch. Choose the used resistor value/combination.
DRS Normal
Open
Select if the door release switch is a normally open input or not.
DRS Single
shot
Set Door release to momentary single use.
No DRS
(Web only)
Select to ignore DRS.
If a DC2 is used on the door, this option MUST be selected. If not selected, the door will open.
Reader
Location
(Entry/Exit)
(Web only)
Select the location of the entry and exit readers.
Reader
formats
(Web)
READER
INFO
(Keypads)
Displays format of last card used with each configured reader.
DRS Single
Shot
Changes operation of DRS to single shot instead of remain open.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 193 I-200572
08.12.2023