Each free zone number can be assigned to the zones but the assignment is not fixed. If the
number ‘9’ is assigned to a zone, the zone and an input expander with the address ‘1’ is
connected to the X-Bus (which is using the zone numbers 9–16). The assigned zone from the
two door controller will be moved to the next free zone number. Configuration will be adapted
accordingly.
Door attributes
If no attribute is activated, a valid card can be used.
Attribute Description
Door Group Used when multiple doors are assigned to the same area and/or anti passback, custodian, or
interlock functionality is required.
Card and PIN Card and PIN are required to gain entry.
PIN Only PIN is required. No card will be accepted.
PIN Code or
Card
PIN or card are required to gain entry
PIN to Exit PIN is required on exit reader. Door with entry and exit reader is required.
PIN to
Set/Unset
PIN is required to set and unset the linked area. The card has to be presented before the PIN
is entered.
Unset
outside
(Browser)
Panel/area will unset, when card is presented at entry reader.
Unset inside
(Browser)
Panel/area will unset, when card is presented at exit reader.
Bypass alarm Access is granted if an area is set and the door is an alarm or an entry zone type.
Double
unlocks
The door unlocks and stays unlocks when double-badged. Door must be double-badged
after exit to reset. This option cannot be used with Settings options.
Fullset
outside
(Browser)
Panel/area will fullest, when card is presented twice at entry reader.
Fullset inside Panel/area will fullest, when card is presented twice at exit reader.
Force Fullset If the user has rights, they can force set from entry reader.
Emergency Door lock opens if a fire alarm is detected within the assigned area.
Emergency
any
Fire in any area will unlock the door.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 194 I-200572
08.12.2023
To Next Page