Acre SPC42 - Page 237

Test Calls Enable the test call by choosing a time interval. This will send out an
automatic test call from modem 1 to the primary ARC.
Test All Check this box if you want to initiate also an automatic test call from
modem 2 to the backup ARC.
6. Click the Add button to enter those details on the system.
A list of the configured ARC accounts will be displayed in the browser along with the account
information, description, protocol, dial-up status and time and date of the last call to the ARC.
Editing an ARC filter using SIA or CID
To configure the events on the SPC that will trigger the call to the ARC:
1. Select Select Communications > Reporting > Analog ARC > Edit > Filter.
2. Configure the following fields:
Check any of the following boxes if you want to initiate a remote call to the ARC to notify it of the
particular event.
Alarms Alarms are activated.
Alarm
Restores
System alarms are restored.
Confirmed
Alarms
Alarms confirmed by multiple zones
Alarm Abort Alarm Abort events. Alarms are aborted after a valid user code is entered via
the keypad after a confirmed or unconfirmed alarm,
Faults Faults and tampers are activated.
Fault
Restores
Fault or tamper alarms are restored.
Settings System is Set and Unset.
Early/Late Unscheduled setting and unsetting of the system.
Inhibits Inhibit and isolate operations are performed on the system.
Door Events Door events are activated. Only works with SIA protocol.
Other All other types of events are detected on the system.
Network Report IP Network Polling Up/Down events.
Areas Select specific areas to which above events apply.
By adding a separate Alarm Receiving Centre (ARC) for each area defined on the system and
programming each area to report it’s own separate ARC receiver, the system can approximate a
multi-tenanted system in that a high degree of autonomy is assigned to each area.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 237 I-200572
08.12.2023