Zone Type
Processing
Category
Description
LOCK ELEMENT Intruder If using a Lock Element (bolt) with a Blockschloss, this zone type
signals the position of the lock element to the panel (locked or
unlocked). This bolt locks the door in the set state. This signal is
checked during setting process. If the ‘locked‘information is not
received, the setting will fail.
GLASSBREAK Intruder Zone is connected to an RI S 10 D-RS-LED glassbreak interface in
combination with GB2001 glassbreak detectors.
l
This zone type is available on controllers and expanders.
It is not available as wireless or as a door zone type if the DC2 is
configured as a door.
l
The zone type reports in the same way as an alarm zone over SIA
and contact ID.
l
The rights to restore/inhibit/isolate glassbreak are the same as the
alarm zone type
l
Power up condition — As the power is supplied by the panel any
state changes within the first 10 seconds are ignored in order to
allow the device to settle.
l
Reset condition — Signals are ignored from the glassbreak
interface for 3 seconds after the device has been reset.
l
Exiting engineer mode — The glassbreak output may be toggled
when exiting engineer mode, in which case the signals from this
sensor will be temporarily ignored for 3 seconds.
WATER This zone type follows the same behaviours as a Technical zone type.
HEAT This zone type follows the same behaviours as a Technical zone type.
FRIDGE/FREEZER This zone type follows the same behaviours as a Technical zone type.
GAS This zone type follows the same behaviours as a Technical zone type.
SPRINKLER This zone type follows the same behaviours as a Technical zone type.
CO This zone type follows the same behaviours as a Technical zone type.
ENTRY/EXIT 2 This zone type follows the same behaviours as an Entry/Exit zone type
with a separate Entry timer. This is so that there can be two entry
timers to a building from different points.
SPC42/52/53/63 – Installation & Configuration Manual Appendix
© Vanderbilt 2023 282 I-200572
08.12.2023
To Next Page