Setting Description
Keyswitch Select if keypad should be limited by a keyswitch.
PACE Entry Tick this box to disable the keys on the keypad during the entry time when a PACE is
configured on the keypad.
Areas
Location Select the secured area where the keypad is located.
Areas Select which areas can be controlled through keypad.
Options
Delay Fullset Select to configure a delayed set across all keypads. The location of the keypad is ignored and
all areas will perform a full exit time count down.
NOTICE: An area should be assigned to a keypad only if the keypad is inside the assigned area,
and if an entry/exit route is defined. If an area is assigned, when the particular area is set or
unset then entry and exit timers are used (if configured). Other features related to entry/exit
routes also become available. If no area is assigned, the area is set or unset immediately and
other entry/exit features are not available.
14.6.4.4 Edit Expanders
To edit expanders:
1. Scroll to EXPANDERS > EDIT.
2. Press SELECT.
3. Scroll to the device to be edited and press SELECT.
Parameters and details, if applicable, are displayed for editing.
4. Press BACK to exit the menu.
For naming and identifying, expanders are allocated zones (in groupings of 8) with subsequent
identities of 1 to 512. (The greatest number in zone identification is 512.) Therefore, any
expander named or identified by a number greater than 63 has no allocated zones.
Editing IO Expanders
The following table lists the available options for IO expanders:
Function Description
Description Edit the description of the expander.
Editing Audio Expanders
The following table lists the options available in the Edit menu for Audio Expanders:
Name Description
DESCRIPTION Enter or edit a description for the audio expander.
INPUT Select the zone’s input.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 82 I-200572
08.12.2023
To Next Page