6253 DC Voltage Current Source/Monitor Operation Manual
5.1.2 Compatibility
5-2
5.1.2 Compatibility
The 6243-compatible mode has some functional restrictions to enhance the compatibility.
In order to optimize the functions of the 6253, it is recommended to use the normal mode unless the
compatibility should be considered.
For more information on the compatibility, also refer to the following sections:
5.7 Data Output Format (Talker Format)
5.8.3 Remote Command List
• In the compatible mode, the following commands require specifying the unit.
Normal mode
Linear sweep SN
[<st>,
<sp>,
<step>]
<st>: Start value
<sp>: Stop value
<step>: Step value (The polarity is ignored.)
When omitting all the setting values, set the sweep type only.
However, it is impossible to omit them respectively.
SN? Response: SN<st>, <sp>, <step>
st, sp, step : <d.dddddEd>
Compatible mode
Linear sweep SN
[<st>,
<sp>,
<step>]
<st>UNIT: Start value
<sp>UNIT: Stop value
<step>UNIT: Step value (The polarity is ignored.)
When omitting all the setting values, set the sweep type only.
However, it is impossible to omit them respectively.
SN? Response: SN<st>, <sp>, <step>
st, sp, step : <d.dddddEd>UNIT
To Next Page
