ADCMT 6253 - Page 203

6253 DC Voltage Current Source/Monitor Operation Manual
5.8.3 Remote Command List
5-35
Source Slew rate
value
SRW
<data1>
[,<data2>]
Slew rate value setting (unit: V/s)
*1
The rise time and fall time values can be set for the
slew rate.
• When specifying data1 and data2, data1 is the
rise time and data2 is the fall time.
• When omitting data2, data 1 is both the rise time
and the fall time.
10.0 V/s Yes
SRW? Response: SRW<srr>,<srr>
*1
srr: <dd.ddE+d> (slew rate rise time)
srf: <dd.ddE+d> (slew rate fall time)
Yes Yes
Sweep Linear sweep SN [<st>,
sp>,
<step>]
<st>: Start value
0.01 mV/
0.01 A
Yes
<sp>: Stop value
1 mV/
1 A
<step>: Step value (The polarity is ignored.)
0.01 mV/
0.01 A
If all the settings are omitted, set the sweep type
only. However, it is not allowed to omit each value
separately.
SN? Response: SN <st>, <sp>, <step>
*1
st, sp, step: <d.dddddEd>
Yes Yes
Fixed level
sweep
SF
[lvl>,
<cnt>]
lvl: Level source value
0 V/0 A Yes
cnt: Sampling count (1 to 20000)
1
If all the settings are omitted, set the sweep type
only. However, it is not allowed to omit each value
separately.
SF? Response: SF<lvl>,<cnt>
*1
lvl: <d.ddddEd>
cnt: <ddddd>
Yes Yes
Log sweep SG [<st>,
<sp>,
<step>]
<st>: Start value
0.01 mV/
0.01 A
Yes
<sp>: Stop value
1 mV/
1 A
<step>: Number of partitions by ten (1, 2, 5, 10, 25,
50)
10
If all the settings are omitted, set the sweep type
only. However, it is not allowed to omit each value
separately.
SG? Response: SG<st>,<sp>,<step>
*1
st,sp:<d.dddddE±d>
step :<dd>
Yes Yes
Random
sweep
SC [<st>,
<sp>]
st: Start address (0 to 19999)
0Yes
*3
sp: Stop address (0 to 19999)
0
If all the settings are omitted, set the sweep type
only. However, it is not allowed to omit each value
separately.
SC? Response: SC<st>, <sp>
st, sp: <ddddd>
Yes Yes
*1: The decimal point position in response varies depending on the setting value.
For the source value, limit value, and time parameter setting ranges, refer to the specifications.
*3: At sweep stop in the Operate status, the values can be changed only between the start and stop addresses that were set in the Standby or
Suspend status.
Item Command Description
Default Operation possibility
Power
ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS