ADCMT 6253 - Page 204

6253 DC Voltage Current Source/Monitor Operation Manual
5.8.3 Remote Command List
5-36
Sweep Multi-slop
linear sweep
SE
[<cnt>,
<1d>,2d>
,<3d>,4
d>,ld>]
cnt: Number of slopes (2 to 4)
2Yes
1d: 1st value
0.01 mV/
0.01 A
2d: 2nd value
1 mV/
1 A
3d: 3rd value
2 mV/
2 A
4d: 4th value
3 mV/
3 A
ld: Last value
2 mV/
2 A
If all the settings are omitted, set the sweep type
only. However, it is not allowed to omit each value
separately.
SE? Response:
SE<cnt>,<1d>,<2d>,<3d>,<4d>,<ld>
<cnt>:<d>1d,2d,3d,4d,ld: <d.dddddEd>
*1
SES
<st1>,<st2>,
<st3>,<st4>
st1: 1st step value (polarity ignored)
0.01 mV/
0.01 μA
Yes
st2: 2nd step value (polarity ignored)
0.02 mV/
0.02 μA
st3: 3rd step value (polarity ignored)
0.03 mV/
0.03 μA
st4: 4th step value (polarity ignored)
0.04 mV/
0.04 μA
SES? Response: SES<st1>,<st2>,<st3>,<st4>
st1,st2,st3,st4: <d.dddddE±d>
*1
Sweep type SX? The sweep type of the present source function is
returned.
Response: Linear sweep:
Same as the SN? response
Fixed level sweep
Same as the SF? response
Log sweep:
Same as the SG? response
Random sweep:
Same as the SC? response
Multi-slope linear sweep:
Same as the SE? response
Yes Yes
*1: The decimal point position in response varies depending on the setting value.
For the source value, limit value, and time parameter setting ranges, refer to the specifications.
Item Command Description
Default Operation possibility
Power
ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS