6 Method Parameters
Set up a Peak-Based Experiment Graphically
2D-LC User Guide 170
Figure 85 Two selected peaks in peak based mode and corresponding peak-based sampling
table
To generate a peak based event in the preview, you can also use the add icon or
do a right click somewhere into the preview, and press add cut.
In the sampling table you can add the events start and end peak-based, see “Use
Peak Trigger” on page 148 .
For adjusting the peak-based area it can be either be done by grabbing start and
end bracket and moving along in the preview or by adjusting the times in the
sampling table.
To Next Page
Loading...
