Agilent Technologies 4155B User Manual

Agilent 4155B/4156B User’s Guide Vol.2, Edition 5 4-3
Making a Measurement
Connecting DUT
Connecting DUT
This section describes how to connect device under test (DUT) to the 16442A test
fixture, and how to connect cables to the connector plate.
For connecting the test fixture or the connector plate to the 4155B/4156B, see User's
Guide General Information. If you use a wafer prober, see wafer prober manuals.
Note that you must set the 4155B/4156B to the idle state when connecting or
disconnecting DUTs. If not, the DUTs may be damaged.
To set to idle state, press
Stop key and make sure Standby indicator is off.
This section has the following descriptions:
•“Using Test Fixture”
•“Using Connector Plate”

Agilent Technologies 4155B Specifications

General

Brand	Agilent Technologies
Model	4155B
Category	Measuring Instruments
Language	English