5-34 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
Analyzing Measurement Results
Automatic Analysis
To Draw Regression Line by Specifying Two Points
1. Press Display front-panel key.
2. Confirm that ON is set on the LINE secondary softkey on the GRAPH/LIST:
GRAPHICS screen.
3. Select ANLYSIS SETUP primary softkey. The DISPLAY: ANALYSIS SETUP
screen is displayed.
4. In field (1), select REGRESSION secondary softkey.
5. In field (2), select secondary softkey to specify desired axis.
6. In field (3), select:
• BY X-Y COORDINATE secondary softkey to specify a point by X-Y
coordinate mode. (Go to step 6.)
• BY DATA CONDITION secondary softkey to specify a point by data
condition mode. (Go to step 7.)
7. If you selected BY X-Y COORDINATE secondary softkey:
a. In the X field, enter desired expression to specify X coordinate.
b. In the Y field, enter desired expression to specify Y coordinate.
c. Go to step 8.
8. If you selected BY DATA CONDITION secondary softkey:
a. In field (4), select secondary softkey to set desired data variable name.
b. In field (5), enter desired expression.
c. In field (6), select:
• AFTER secondary softkey if you want to set a search start condition for
finding specified point.
• DISABLE secondary softkey to disable (clear) the AFTER settings.
d. If you selected AFTER, select secondary softkey to enter desired data
variable in field (7).
e. If you selected AFTER, enter desired expression in field (8).
9. Specify the other point by step 5, then step 6 or 7.
To Next Page
Loading...
Need help?
General
