8-14 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
If You Have A Problem
If Errors Occur
If Errors Occur when You Perform Self-calibration or
Diagnostics
The following are the error codes that are displayed at the bottom of the SYSTEM:
SELF-CALIBRATION/DIAGNOSTICS screen if errors occur when you perform
self-calibration or diagnostics.
If errors occur, write down the displayed error codes and contact the nearest Agilent
Technologies Sales and Service office. Up to seven error codes can be displayed at
the bottom of the SYSTEM: SELF-CALIBRATION/DIAGNOSTICS screen. To
display the error codes, move pointer to a desired test item.
Error codes for measurement unit
The following are the error codes for measurement units. Error codes are 5-digit
numbers.
1xxyy
• xx: measurement unit
• 00: VSU1,2 and VMU1,2
• 01 to 06: SMU1 to SMU6
• 07: PGU1,2
• 08: GNDU
• 09: AD converter
• yy: error number
1xx05 AD converter failed ROM or RAM self-test. Measurement unit failed
AD converter test as a pretest for calibration or self-test.
1xx06 Successive approximation AD converter failed. Measurement unit
failed AD converter test as a pretest for calibration or self-test.
1xx07 Integrating type AD converter failed. Measurement unit failed AD
converter test as a pretest for calibration or self-test.
1xx08 AD converter test reached timeout. Measurement unit failed AD
converter test as a pretest for calibration or self-test.
1xx11 Overvoltage occurred for a measurement unit.
1xx12 Overcurrent occurred for a measurement unit.
To Next Page
Loading...
Need help?
General
