4-54 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
Making a Measurement
Stress Force
To set hold time
In the HOLD TIME field, set desired value. For the meaning of hold time, see
“Stress Force Sequence” in Chapter 3.
Setting the Accumulated Stress Time
The ACCUMULATED STRESS field shows the total stress that has been forced. If
necessary, you can change the value in this field. If so, the ACCUMULATED
STRESS field on the STRESS: STRESS FORCE screen also changes to the new
value.
Example
The following figure shows an example setup of stress condition.
To Next Page
Loading...
Need help?
General
