Agilent 4155B/4156B User’s Guide Vol.2, Edition 5 6-37
Screen Organization
DISPLAY Screen Group
• NAME
NAME fields specify the variable names that you want to assign to the axes,
which will be plotted on the GRAPHICS screen. In this field, you can select the
desired variable names in the secondary softkey area.
The entries in these fields and the data variable fields determine which channels
will actually make measurements.
• SCALE
The SCALE fields specify linear or logarithmic scale for the axis by selecting
LINEAR or LOG secondary softkey.
• MIN and MAX
MIN and MAX fields specify the minimum and maximum values for the axis.
The minimum and maximum values are automatically set according to the
NAME and SCALE settings. You can modify these values if desired.
GRID
In the GRID field, you can specify whether to display the grid on the plotting area
by selecting ON or OFF secondary softkey.
LINE PARAMETER
In the LINE PARAMETER field, you can specify whether to display X and Y
intercepts and gradients of lines on the plotting area by selecting ON or OFF
secondary softkey.
OFF The line parameters are not displayed.
ON The line parameters are displayed when lines are displayed on the graph.
DATA VARIABLES
In the DATA VARIABLES fields, you can enter two variable names. The numerical
values of these variables will be shown on the GRAPHICS screen according to the
marker position. In this field, you can select the desired variable names in the
secondary softkey area.
Even if the setup data variables are defined using variables that are not set in the
NAME field of the GRAPHICS table, the variables are automatically measured after
pressing a measurement front-panel key.
To Next Page
Loading...
Need help?
General
