AC Line Power Supply Requirements Installation and Maintenance
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition 295
Changing the Battery
Changing the Fuse
The Agilent 8163A Lightwave Multimeter System, Agilent 8164A
Lightwave Measurement System, and the Agilent 8166A Lightwave
Multichannel System contain a disc shaped Lithium Thionyl
Chloride battery.
The Agilent 8163B Lightwave Multimeter System, Agilent 8164B
Lightwave Measurement System, and the Agilent 8166B Lightwave
Multichannel System contain a cylindrical (˝ AA size) Lithium
Manganese Dioxode battery.
The battery is not user replaceable. The battery is protected against
loading by a special circuit and must be installed with the correct
polarity. Changing the battery should be carried out only by Agilent
Technologies service personnel. If you need to get the battery
replaced refer to your nearest Agilent Technologies Sales/Service
Office.
CAUTION
There is no user replaceable fuse for the Agilent 8163A/B
Lightwave Multimeter System, Agilent 8164A/B Lightwave
Measurement System, and the Agilent 8166A/B Lightwave
Multichannel System. Changing the fuse should be carried out only
by Agilent Technologies service personnel. If you need to get the
fuse replaced refer to your nearest Agilent Technologies
Sales/Service Office.
The Agilent 8163A/B contains a F5.0A/250V fast-acting fuse.
The Agilent 8164A/B and Agilent 8166A/B contain a F10.0A/250V
fast-acting fuse.
CAUTION
To Next Page
Loading...
Need help?
General
