EasyManuals Logo

Alcatel-Lucent 7210 SAS M Service Guide

Alcatel-Lucent 7210 SAS M
952 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #392 background imageLoading...
Page #392 background image
Virtual Private LAN Services
Page 392 7210 SAS M Services Guide
service-name
Syntax service-name service-name
no service-name
Context config>service>vpls
Description This command configures an optional service name, up to 64 characters in length, which adds a name
identifier to a given service to then use that service name in configuration references as well as
display and use service names in show commands throughout the system. This helps the service
provider/administrator to identify and manage services within the 7750 SR, 7450 ESS and 7710 SR
platforms.
All services are required to assign a service ID to initially create a service. However, either the service
ID or the service name can be used o identify and reference a given service once it is initially created.
Parameters service-name — Specifies a unique service name to identify the service. Service names may not begin
with an integer (0-9).
allow-ip-int-binding
Syntax [no] allow-ip-int-binding
Context config>service>vpls
Description The allow-ip-int-binding command that sets a flag on the VPLS service that enables the ability to
attach an IES IP interface to the VPLS service in order to make the VPLS service routable. When the
allow-ip-int-binding command is not enabled, the VPLS service cannot be attached to an IP interface.
Please refer to the Virtual Private LAN Service on page 243 for VPLS Configuration Constraints for
Enabling allow-ip-int-binding.
When attempting to set the allow-ip-int-binding VPLS flag, the system first checks to see if the
correct configuration constraints exist for the VPLS service and the network ports. In Release 5.0 the
following VPLS features must be disabled or not configured for the allow-ip-int-binding flag to set:
• SAP ingress QoS policies applied to the VPLS SAPs cannot have MAC match criteria defined
• The VPLS service type cannot be B-VPLS or M-VPLS and it cannot be an I-VPLS service bound
to a B-VPLS context
• MVR from Routed VPLS and to another SAP is not supported
Once the VPLS allow-ip-int-binding flag is set on a VPLS service, the above features cannot be
enabled on the VPLS service.
VPLS SERVICE NAME BOUND TO IP INTERFACE WITHOUT ALLOW-IP-INT-BINDING
FLAG SET
In the event that a service name is applied to a VPLS service and that service name is also bound to an
IP interface but the allow-ip-int-binding flag has not been set on the VPLS service context, the system
attempt to resolve the service name between the VPLS service and the IP interface will fail. After the
allow-ip-int-binding flag is successfully set on the VPLS service, either the service name on the
VPLS service must be removed and reapplied or the IP interface must be re-initialized using the
shutdown or no shutdown commands. This will cause the system to reattempt the name resolution
process between the IP interface and the VPLS service.

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS M and is the answer not in the manual?

Alcatel-Lucent 7210 SAS M Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS M
CategorySwitch
LanguageEnglish

Related product manuals