Alcatel-Lucent 7210 SAS M - Page 468

Show Commands
Page 468 7210-SAS M Services Guide
Sample Output
*A:alcag1-R6# oam eth-cfm loopback 00:af:af:af:af:af mep 51 domain 1 association 1
eth-cfm Loopback Test Initiated: Mac-Address: 00:af:af:af:af:af, out sap: 1/2/9:5
Sent 1 packets, received 1 packets [0 out-of-order, 0 Bad Msdu] -- OK
*A:alcag1-R6#
*A:alcag1-R6# oam eth-cfm linktrace 00:af:af:af:af:af mep 51 domain 1 association 1
Index Ingress Mac Egress Mac Relay Action
----- -------------------- -------------------- ---------- ----------
1 00:00:00:00:00:00 00:AF:AF:AF:AF:AF rlyHit terminate
----- -------------------- -------------------- ---------- ----------
No more responses received in the last 5 seconds.
*A:alcag1-R6#
id
Syntax id service-id
Context show>service
Description This command displays information on a specific service ID.
Parameters service-id — The unique service identification number that identifies the service in the service
domain.
Values service-id: 1 — 214748364
all — Displays detailed information about the service.
base — Displays basic service information.
fdb — Displays FDB entries.
epipe — Displays the e-pipe services associated with the B-VPLS service.
i-vpls — Displays the I-VPLS services associated with this B-VPLS service.
stp — Display STP information.
all
Syntax all
Context show>service>id
Description Displays detailed information for all aspects of the service.
Output Show All Service-ID Output — The following table describes the show all service-id command
output fields: