Alcatel-Lucent 7210 SAS M - Page 521

Internet Enhanced Services
7210-SAS M Services Guide Page 521
VRRP Commands (applicable only for network mode)
config
—service
— ies service-id [customer customer-id] [vpn vpn-id]
— interface ip-int-name
—
— vrrp virtual-router-id [owner]
—no vrrp virtual-router-id
— authentication-key {authentication-key | hash-key} [hash |
hash2]
—no authentication-key
— [no] backup ip-address
— [no] init-delay [service-id] interface interface-name dst-ip ip-
address
— init-delay seconds
—no init-delay
— mac ieee-address
—no mac
— [no] master-int-inherit
— message-interval {[seconds] [milliseconds milliseconds]}
—no message-interval
— [no] ping-reply
— policy
vrrp-policy-id
—no policy
— [no] preempt
— priority priority
—no priority
— [no] shutdown
— [no] ssh-reply
— [no] standby-forwarding
— [no] telnet-reply
— [no] traceroute-reply
Interface IPv6 commands (supported only for access-uplink SAPs)
config