Show, Clear, Debug Commands
Page 734 7210-SAS M Services Guide
Admin State
Specifies the operating status of the keepalive protocol.
Oper State
The current status of the keepalive protocol.
Hello Time
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Hello Msg Len
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Max Drop Count
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
SDP Delivery Mech-
anism
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far end field.
Max Drop Count
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Number of SDPs
The total number SDPs applied to this service ID.
Service Access Points
Service Id
The service identifier.
Port Id
The ID of the access port where this SAP is defined.
Description
Generic information about the SAP.
Admin State
The desired state of the SAP.
Oper State
The operating state of the SAP.
Last Changed
The date and time of the last change.
Admin MTU
The desired largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
Oper MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Ingress qos-pol-
icy
The SAP ingress QoS policy ID.
Egress qos-policy
The SAP egress QoS policy ID. This command is applicable only to
7210 SAS X.
Label Description
To Next Page
Loading...
Need help?
General
