EasyManuals Logo

Alcatel-Lucent 7210 SAS M Service Guide

Alcatel-Lucent 7210 SAS M
952 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #735 background imageLoading...
Page #735 background image
VPRN Show Commands
7210-SAS M Services Guide Page 735
Acct. Pol
Indicates the accounting policy applied to the SAP.
Collect Stats
Specifies whether accounting statistics are collected on the SAP.
Spoke SDPs
Managed by Service
Specifies the service-id of the management VPLS managing this spoke
SDP.
Managed by Spoke
Specifies the sap-id inside the management VPLS managing this spoke
SDP.
Prune state
Specifies the STP state inherited from the management VPLS.
Peer Pw Bits
Indicates the bits set by the LDP peer when there is a fault on its side of
the pseudowire. LAC failures occur on the SAP that has been config-
ured on the pipe service, PSN bits are set by SDP-binding failures on
the pipe service. The pwNotForwarding bit is set when none of the
above failures apply, such as an MTU mismatch failure. This value is
only applicable if the peer is using the pseudowire status signalling
method to indicate faults.
pwNotForwarding — Pseudowire not forwarding
lacIngressFault Local — Attachment circuit RX fault
lacEgresssFault Local — Attachment circuit TX fault
psnIngressFault Local — PSN-facing PW RX fault
psnEgressFault Local — PSN-facing PW TX fault
pwFwdingStandby — Pseudowire in standby mode
Max IPv4 Routes
Maximum IPv4 routes configured for use with the service.
Last Changed
The date and time of the most recent management-initiated change.
Dot1Q Ethertype
The Dot1q ethertype in use by the SAP.
Ingr IP Fltr-Id
The policy ID of the IP filter applied at ingress.
Ingr Mac Fltr-Id
The policy ID of the MAC filter applied at ingress.
Egr IP Fltr-Id
The policy ID of the IP filter applied at egress.
Egr Mac Fltr-Id
The policy ID of the MAC filter applied at egress.
tod-suite
The TOD suite applied for use by this SAP.
rate
Specifies the SAP aggregate rate configured for the aggregate policer/
meter used by this SAP.
burst
Specifies the burst to be used with SAP aggregate policer/meter used
by this SAP.
Classifiers Allo-
cated
Number of SAP ingress QoS resources allocated for use by this SAP.
Classifiers Used
Number of SAP ingress QoS resources in use by this SAP.
Meters Allocated
Number of SAP ingress meter resources allocated for use by this SAP.
This is set to half the number of classifiers allocated to this SAP.
Label Description

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS M and is the answer not in the manual?

Alcatel-Lucent 7210 SAS M Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS M
CategorySwitch
LanguageEnglish

Related product manuals