Alcatel-Lucent 7750 SR OS - Page 1060

VPRN Service Configuration Commands
Page 1060 7750 SR OS Services Guide
Description Use this command to define the length of time neighboring router consider this router to be up.
Use the no form of this command to revert to the default value.
Default 150
Parameters holdtime — Specify the length of time, in seconds, that neighbor should consider the sending router to
be operational.
Values 0 — 255
priority
Syntax priority priority
no priority priority
Context config>router>pim>rp>local
config>service>vprn>pim>rp>rp-candidate
Description This command defines the priority used to become the rendezvous point (RP). The higher the priority
value, the more likely that this router will become the RP.
Use the no form of this command to revert to the default value.
Default 1
Parameters priority — Specify the priority to become the designated router. The higher the value the more likely
the router will become the RP.
Values 0 — 255
static
Syntax static
Context config>service>vprn>pim>rp
Description This command enables access to the context to configure a static rendezvous point (RP) of a PIM-SM
protocol instance.
Default none
address
Syntax [no] address ip-address
Context config>service>vprn>pim>rp>static
Description This command configures the static rendezvous point (RP) address.
The no form of this command removes the static RP entry from the configuration.
Default none