Alcatel-Lucent 7750 SR OS - Deleting Lsps; Modifying Lsps

Services
7750 SR OS Services Guide Page 73
config>service>epipe# exit
config>service# no sdp 79
Modifying LSPs
Although the CLI command descriptions are discussed in the MPLS chapter of this book, the
syntax is repeated in this section as a quick reference.
To access a specific LSP, you must specify the LSP ID. To display a list of LSPs, use the
show
router mpls lsp
command. Enter the parameter, such as from, to, retry-timer, retry-
limit
, primary, and secondary, and then enter the new information.
CLI Syntax: config>router>mpls# lsp lsp-name
Example
: config>router>mpls# lsp to-headquarters
config>router>mpls>lsp# fast-reroute hop-limit 35
config>router>mpls>lsp# primary to-104
config>router>mpls>lsp# bandwidth 50000
config>router>mpls>lsp# no shutdown
Deleting LSPs
The no form of the lsp command removes an LSP ID and all associated information. Before an
LSP can be deleted, the LSP must be removed from all SDP associations. The SDP must be
administratively disabled before deleting LSPs.
CLI Syntax: config>router# mpls
[no] lsp lsp-name
shutdown
CLI Syntax: config>service# sdp sdp-id
[no] lsp lsp-name
Example
: config>service# sdp 79
config>service>sdp# no lsp 123
config>service>sdp# exit all
# config router
config>router# mpls
config>router>mpls# lsp 123
config>router>mpls>lsp# shutdown
config>router>mpls>lsp# exit
config>router>mpls# no lsp 123