Alcatel-Lucent 7750 SR OS - List of Commands

Configuring a VPLS Service with CLI
Page 362 7750 SR OS Services Guide
List of Commands
Table 13 lists all the service configuration commands indicating the configuration level at which
each command is implemented with a short command description. VPLS services are configured
in the
config>service>vpls context. The command list is organized in the following task-
oriented manner:
• Configure a VPLS service
→ Configure VPLS STP parameters
→ Configure VPLS multicast FIB parameters
→ Configure VPLS IGMP parameters
→ Configure Split Horizon Group parameters
• Configure VPLS multicast FIB parameters
→ Configure VPLS IGMP parameters
• Configure a VPLS SAP
→ Configure SAP ATM parameters
→ Configure SAP egress parameters
→ Configure SAP ingress parameters
→ Configure SAP STP parameters
→ Configure SAP subscriber management parameters
• Configure mesh SDP parameters
• Configure spoke SDP parameters
→ Configure spoke SDP STP parameters
• Configure an egress multicast group
→ Applying an egress multicast group to a VPLS SAP
• Configure a PE discovery policy
→ Applying a PE discovery policy to VPLS
Table 1: CLI Commands to Configure VPLS Service Parameters
Command Description Page
Configure a VPLS service
config>service# vpls service-id [customer customer-id] [vpn vpn-id]
459
customer
Specifies the existing customer ID number to be associated with the
service.
459
vpn
Specifies the VPN ID number which allows you to identify virtual
private networks (VPNs) by a VPN identification number.
459