Configuring a VPLS Service with CLI
Page 368 7750 SR OS Services Guide
scheduler-override
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
515
scheduler-policy
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
517
Configure SAP ingress parameters
config>service>vpls>sap#
ingress
Configures ingress SAP QoS policies and filter policies. 504
filter
Associates an IP filter policy or MAC filter policy with an ingress SAP
or IP interface.
505
match-qinq-dot1p
Configures filtering based on the p-bits in the top or bottom tag of a Q-
in-Q encapsulated Ethernet frame.
518
qos
Associates a Quality of Service (QoS) policy with an ingress SAP or IP
interface.
507
queue-override
Enables the context to configure override values for the specified SAP
egress QoS queue.
508
queue
Specifies the ID of the queue whose parameters are to be overridden. 508
adaptation-rule
Overrides specific attributes of the specified queue’s adaptation rule
parameters.
509
cbs
Overrides specific attributes of the specified queue’s CBS parameters. 511
high-prio-only
Overrides specific attributes of the specified queue’s high-prio-only
parameters.
512
mbs
Overrides specific attributes of the specified queue’s MBS parameters. 513
rate
Overrides specific attributes of the specified queue’s Peak Information
Rate (PIR) and the Committed Information Rate (CIR) parameters.
514
scheduler-override
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
515
scheduler-policy
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
517
scheduler-policy
Associates an existing scheduler policy to an ingress scheduler used by
SAP queues associated with this multi-service customer site.
517
Configure SAP STP parameters
config>service>vpls>sap>stp#
auto-edge
Configures automatic detection of the edge port characteristics of the
SAP or spoke SDP.
483
edge-port
Configures the SAP as an edge or non-edge port. 483
link-type
Instructs STP on the maximum number of bridges behind this SAP. 485
Table 1: CLI Commands to Configure VPLS Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
