Service Management Tasks
Page 1340 7750 SR OS Services Guide
Deleting a Remote Mirrored Service
Existing mirroring parameters can be deleted in the CLI. A shut down must be issued on a service
level in order to delete the service. It is not necessary to shut down or remove SAP, SDP, or far-
end references to delete a remote mirrored service. Refer to page 1335 for the complete list of
commands and options.
Mirror destinations must be shut down first before they can be deleted.
Example:*A:ALA-A>config>mirror# mirror-dest 105
config>mirror>mirror-dest# shutdown
config>mirror>mirror-dest# exit
config>mirror# no mirror-dest 105
config>mirror# exit
*A:ALA-B>config>mirror# mirror-dest 105
config>mirror>mirror-dest# shutdown
config>mirror>mirror-dest# exit
config>mirror# no mirror-dest 105
config>mirror# exit
The mirror-destination service ID 105 was removed from the configuration on ALA-A and ALA-
B, thus, does not appear in the
info command output.
*A:ALA-A>config>mirror# info
----------------------------------------------
----------------------------------------------
*A:ALA-A>config>mirror# exit
*A:ALA-B>config>mirror# info
----------------------------------------------
----------------------------------------------
*A:ALA-B>config>mirror# exit
Since the mirror destination was removed from the configuration on ALA-B, the port information
was automatically removed from the
debug mirror-source configuration.
*A:ALA-B# show debug mirror
debug
exit
*A:ALA-B#
To Next Page
Loading...
