Virtual Private LAN Services
7750 SR OS Services Guide Page 361
Configuring a VPLS Service with CLI
VPLS This section provides information to configure VPLS services using the command line interface.
Topics in this section include:
• List of Commands on page 362
• Basic Configuration on page 373
• Common Configuration Tasks on page 375
→ Configuring VPLS Components on page 376
− Creating a VPLS Service on page 378
− Configuring a VPLS SAP on page 386
• Local VPLS SAPs on page 386
• Distributed VPLS SAPs on page 387
• Configuring SAP Subscriber Management Parameters on page 399
− Configuring SDP Bindings on page 400
• Configuring VPLS Redundancy on page 413
− Creating a Management VPLS for SAP Protection on page 413
− Creating a Management VPLS for Spoke SDP Protection on page 416
− Configuring Load Balancing with Management VPLS on page 419
• ATM/Frame Relay PVC Access and Termination on a VPLS Service on page 426
• Configuring Provider Edge Discovery Policies on page 428
→ Applying a PE Discovery Policy to a VPLS Service on page 430
• Configuring Policy-Based Forwarding for Deep Packet Inspection in VPLS on page 432
• Service Management Tasks on page 436
→ Modifying VPLS Service Parameters on page 436
→ Modifying Management VPLS Parameters on page 437
→ Deleting a VPLS Service on page 439
→ Disabling a VPLS Service on page 439
→ Re-enabling an VPLS Service on page 440
To Next Page
