Configuring a VPRN Service with CLI
Page 906 7750 SR OS Services Guide
Configuring VPRN Protocols - PIM
Refer to VPRN Services Command Reference on page 925 for CLI syntax to configure VPRN
parameters.
The following displays the command usage to configure VPRN PIM parameters:
Example: config>service# vprn 1 customer 2 create
config>service>vprn# route-distinguisher 1:11
config>service>vprn# pim
config>service>vprn>pim# interface if1
config>service>vprn>pim>if$ address 12.13.14.15/32
config>service>vprn>pim>if# loopback
config>service>vprn>pim>if# exit
config>service>vprn>pim# interface if2
config>service>vprn>pim>if$ address 14.14.14.1/24
config>service>vprn>pim>if# sap 1/1/2:0
config>service>vprn>pim>if# exit
config>service>vprn>pim# rp
config>service>vprn>pim>rp# static
config>service>vprn>pim>rp# bsr-candidate
config>service>vprn>pim>rp>bsr-cand# exit
config>service>vprn>pim>rp# rp-candidate
config>service>vprn>pim>rp>rp-cand# exit
config>service>vprn>pim>rp# exit
config>service>vprn>pim# exit
The following example displays the VPRN PIM configurations:
config>service# info
#------------------------------------------
...
vprn 1 customer 2 create
route-distinguisher 1:11
interface "if1" create
address 12.13.14.15/32
loopback
exit
interface "if2" create
address 14.14.14.1/24
sap 1/1/2:0 create
exit
exit
pim
interface "if1"
exit
interface "if2"
exit
rp
static
exit
bsr-candidate
shutdown
exit
To Next Page
Loading...
