Alcatel-Lucent 7750 SR OS - Common Configuration Tasks

Configuring a VPRN Service with CLI
Page 902 7750 SR OS Services Guide
Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed to configure a VPRN
service and provides the CLI commands.
1. Associate a VPRN service with a customer ID.
2. Define an autonomous system (optional).
3. Define an route distinguisher (mandatory).
4. Define VRF route-target associations or VRF import/export policies.
5. Define PIM parameters (optional).
6. Create a subscriber interface (optional).
7. Create an interface.
8. Define SAP parameters on the interface.
→ Select node(s) and port(s).
→ Optional - select QoS policies other than the default (configured in
config>qos
context).
→ Optional - select filter policies (configured in
config>filter context).
→ Optional - select accounting policy (configured in
config>log context).
→ Optional - configure DHCP features.
9. Define BGP parameters (optional).
→ BGP must be enabled in the
config>router>bgp context.
10. Define RIP parameters (optional).
→ RIP must be enabled in the
config>router>rip context.
11. Define spoke SDP parameters.
12. Enable the service.