Alcatel-Lucent 7750 SR OS - Configuring an Ipipe Service

Virtual Leased Line Services
7750 SR OS Services Guide Page 165
Configuring an Ipipe Service
The following fields require specific input (there are no defaults) to configure basic Ipipe service:
• Customer ID (refer to Configuring Customers on page 64)
• Specify SAP parameters
• Specify spoke SDP parameters
The following example displays sample configurations of Ipipe services.
A:ALA-280>config>service>ipipe# info
----------------------------------------------
sap 1/1/4:0 create
ingress
qos 2
exit
egress
qos 1010
exit
ce-address 10.40.30.10
mac 14:30:01:01:00:04
exit
spoke-sdp 3:100 create
ingress
filter ip 10
exit
ce-address 10.40.30.11
exit
no shutdown
----------------------------------------------
A:ALA-280>config>service>ipipe#
A:ALA-49>config>service>ipipe# info
----------------------------------------------
sap 2/1/4:0 create
ingress
qos 2
exit
egress
qos 1010
exit
ce-address 128.251.10.10
exit
spoke-sdp 8:200 create
ingress
filter ip 10
exit
ce-address 128.251.10.11
exit
no shutdown
----------------------------------------------
A:ALA-49>config>service>ipipe#