Alcatel-Lucent 7750 SR OS - Configuring IES SAP ATM Parameters

Configuring an IES Service with CLI
Page 696 7750 SR OS Services Guide
Configuring IES SAP ATM Parameters
Use the following CLI syntax to configure IES SAP ATM parameters.
CLI Syntax: config>service# ies service-id
interface interface-name
sap sap-id
atm
egress
traffic-desc traffic-desc-profile-id
encapsulation encapsulation-type
ingress
traffic-desc traffic-desc-profile-id
oam
alarm-cells
terminate
collect-stats
description description-string
egress
qos policy-id
scheduler-policy scheduler-policy-name
ingress
qos policy-id [shared-queuing]
scheduler-policy scheduler-policy-name
multi-service-site customer-site-name
no shutdown
The following example displays the command usage to create Apipe SAPs:
PE router 1 (A:ALA-41):
Example: A:ALA-41>config>service# ies 5
A:ALA-41>config>service>ies# sap 1/1/1:0/32 create
A:ALA-41>config>service>ies>sap# ingress
A:ALA-41>config>service>ies>sap>ingress# qos 102
A:ALA-41>config>service>ies>sap>ingress# exit
A:ALA-41>config>service>ies>sap# egress
A:ALA-41>config>service>ies>sap>egress# qos 103
A:ALA-41>config>service>ies>sap>egress# exit
A:ALA-41>config>service>ies>sap# no shutdown
A:ALA-41>config>service>ies>sap# exit
A:ALA-41>config>service>ies#
PE router 2 (A:ALA-42):
Example: A:ALA-42>config>service# ies 5
A:ALA-42>config>service>ies# sap 2/2/2:0/32 create
A:ALA-42>config>service>ies>sap# ingress
A:ALA-42>config>service>ies>sap>ingress# qos 102
A:ALA-42>config>service>ies>sap>ingress# exit