Configuring VSM and CCAG with CLI
Page 1240 7750 SR OS Services Guide
List of Commands
Table 40 lists all the configuration commands to provision VSM and service-related commands,
indicating the configuration level at which each command is implemented with a short command
description. The command list is organized in the following task-oriented manner:
• Configure VSM on page 1240
• Configure VSM path parameters on page 1240
• Configure VSM on an MDA on page 1241
• Configure CCAG on a router interface port on page 1241
• Configure CCAG on an Epipe service on page 1241
• Configure CCAG on a VPLS service on page 1241
• Configure CCAG on an IES service on page 1242
• Configure CCAG on an VPRN service on page 1242
Table 1: CLI Commands to Configure VSM Parameters
Command Description Page
Configure VSM
config>vsm
vsm
Changes the current CLI context to the CCA nodal context. 1272
ccag
Creates a Cross Connect Aggregation Group (CCAG). 1272
access
Changes the current CLI context to the CCAG access nodal context. 1274
adapt-qos
Controls how the CCAG SAP queue and virtual scheduler buffering and
rate parameters are adapted over multiple active CCAs.
1274
cca-rate
Defines a maximum forwarding rate for each CCA member within the
CCAG.
1274
description
Defines an informational string associated with the CCAG. 1271
member-cca
Adds and deletes provisioned CCAs from the CCAG. 1275
shutdown
Controls the administrative state of that the command is executed under. 1271
Configure VSM path parameters
config>vsm>path
path
Changes the current CLI context to the path nodal context. 1276
sap-sap
Changes the current CLI context to the path sap-sap nodal context. 1278
sap-net
Changes the current CLI context to the path sap-net nodal context. 1281
net-sap
Changes the current CLI context to the path net-sap nodal context. 1281