Versatile Service Module
7750 SR OS Services Guide Page 1241
mac
Overrides the default MAC address for the path’s context. 1278
mtu
Overrides the default port level MTU for the path’s context. 1278
egress
Changes the current CLI context to the path’s egress context. 1279
ingress
Changes the current CLI context to the path’s ingress context. 1280
pool
Changes the current CLI context to the path’s nodal context. 1279
resv-cbs
Defines the percentage of the buffer pool that is considered reserved for the
CBS buffer allocation for queues created in the path’s pool context.
1279
slope-policy
Defines the slope policy used to mange the shared portion of the buffer
pools WRED slopes.
1280
accounting-policy
Defines the network accounting policy that will be used to define which
statistics will be collected when the collect-stats command is enabled in
the path’s net-sap context.
1282
collect-stats
Enables collecting stats on the path’s net-sap context. 1282
queue-policy
Defines the egress network queues used by IP interfaces bound to the
path’s context
1283
rate
Defines a specific bandwidth rate limitation for the alpha or beta paths on
each member CCA in the CCAG.
1276
weight
Defines a scheduling weight to the aggregate output of the alpha and beta
paths.
1277
Configure VSM on an MDA
config>card>mda
mda
Provisions an adaptor into an MDA position on an IOM slot. 1285
Configure CCAG on a router interface port
config>router>interface>port
port
Cross connects a network IP interface to a CCAG SAP using the referenced
ccag-id.
1286
Configure CCAG on an Epipe service
config>service>epipe service-id
sap
Creates a cross connect SAP on the ccag-id referenced in the Epipe service. 1288
Configure CCAG on a VPLS service
config>service>vpls service-id
sap
Creates a cross connect SAP on the ccag-id referenced in the VPLS
service.
1289
Table 1: CLI Commands to Configure VSM Parameters (Continued)
Command Description Page
To Next Page
Loading...
