Configuring a VLL Service with CLI
Page 166 7750 SR OS Services Guide
Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed to configure the VLL
services and provides the CLI commands.
• Associate the service with a customer ID.
• Define SAP parameters
→ Optional - configure ATM parameters
→ Optional - select egress and ingress QoS and/or scheduler policies (configured in
config>qos context).
→ Optional - select accounting policy (configured in
config>log context).
• Define spoke SDP parameters.
• Enable the service.
Configuring VLL Components
This section provides VLL configuration examples for the VLL services:
• Creating an Epipe Service on page 167
→ Configuring Epipe SAP Parameters on page 168
− Local Epipe SAPs on page 168
− Distributed Epipe SAPs on page 170
− Configuring Ingress and Egress SAP Parameters on page 172
• Creating an Apipe Service on page 176
→ Configuring Apipe SAP Parameters on page 178
→ Configuring Apipe SDP Bindings on page 180
• Creating an Fpipe Service on page 182
→ Configuring Fpipe SAP Parameters on page 183
→ Configuring Fpipe SDP Bindings on page 185
• Creating an Ipipe Service on page 187
→ Configuring Ipipe SAP Parameters on page 187
To Next Page
