OAM and SAA Command Reference
Page 1460 7750 SR OS Services Guide
Show Commands
saa
Syntax saa [test-name] [owner test-owner]
Context show>saa
Description Use this command to display information about the SAA test.
If no specific test is specified a summary of all configured tests is displayed.
If a specific test is specified then detailed test results for that test are displayed for the last three
occurrences that this test has been executed, or since the last time the counters have been reset via a
system reboot or clear command.
Parameters test-name — Enter the name of the SAA test for which the information needs to be displayed. The
test name must already be configured in the config>saa>test context.
This is an optional parameter.
owner test-owner — Specifies the owner of an SAA operation up to 32 characters in length.
Values 32 characters maximum.
Default If a test-owner value is not specified, tests created by the CLI have a default owner
“TiMOS CLI”.
Output SAA Output — The following table provides SAA field descriptions
Sample Output
The following displays an SAA test result:
*A:SR-3>config>saa>test$ show saa
Label Description
Test Name The name of the test.
Owner Name The owner of the test.
Administrative
status
Enabled or disabled.
Test type The type of test configured.
Test runs since
last clear
The total number of tests performed since the last time the tests were
cleared.
Number of failed
tests run
The total number of tests that failed.
Last test run The last time a test was run.
To Next Page
Loading...
