OAM and SAA Command Reference
7750 SR OS Services Guide Page 1461
===============================================================================
SAA Test Information
===============================================================================
Test name : test1
Owner name : TiMOS CLI
Administrative status : Disabled
Test type : cpe-ping service 1 source 192.168.1.1
destination 192.168.1.1
Test runs since last clear : 0
Number of failed test runs : 0
Last test result : Undetermined
-------------------------------------------------------------------------------
Threshold
Type Direction Threshold Value Last Event Run #
-------------------------------------------------------------------------------
Jitter-in Rising None None Never None
Falling None None Never None
Jitter-out Rising None None Never None
Falling None None Never None
Jitter-rt Rising None None Never None
Falling None None Never None
Latency-in Rising None None Never None
Falling None None Never None
Latency-out Rising None None Never None
Falling None None Never None
Latency-rt Rising None None Never None
Falling None None Never None
Loss-in Rising None None Never None
Falling None None Never None
Loss-out Rising None None Never None
Falling None None Never None
Loss-rt Rising None None Never None
Falling None None Never None
===============================================================================
*A:SR-3>config>saa>test$
ldp-treetrace
Syntax ldp-treetrace [prefix ip-prefix/mask] [detail]
Context show>test-oam
Description This command displays OAM LDP treetrace information.
Parameters prefix ip-prefix/mask — Specifies the address prefix and subnet mask of the destination node.
detail — Displays detailed information.
Sample Output
*A:ALA-48# show test-oam ldp-treetrace
Admin State : Up Discovery State : Done
Discovery-intvl (min) : 60 Probe-intvl (min) : 2
Probe-timeout (min) : 1 Probe-retry : 3
Trace-timeout (sec) : 60 Trace-retry : 3
To Next Page
Loading...
