Configuring a VLL Service with CLI
Page 160 7750 SR OS Services Guide
Basic Configurations
• Configuring an Epipe Service on page 160
• Configuring an Apipe Service on page 162
• Configuring an Fpipe Service on page 163
• Configuring an Ipipe Service on page 165
• Using Spoke SDP Control Words on page 191
• Pseudowire Configuration Notes on page 193
→ Configuring Two VLL Paths Terminating on T-PE2 on page 195
→ Configuring VLL Resilience on page 199
→ Configuring VLL Resilience for a Switched Pseudowire Path on page 201
Configuring an Epipe Service
The following fields require specific input (there are no defaults) to configure a basic Epipe
service:
• Customer ID (see Configuring Customers on page 64)
• For a local service, two SAPs must be configured specifying the source and destination
ports
• For a distributed service, one SAP and one SDP must be specified
The following example displays a sample configuration of a local Epipe service configured on
ALA-12.
*A:ALA-12>config>service# info
#------------------------------------------
...
epipe 7 customer 6 vpn 7 create
description "Local epipe service"
sap 1/1/6:0 create
exit
sap 2/1/8:0 create
exit
exit
...
#------------------------------------------
*A:ALA-12>config>service#
The following example displays a sample configuration of a distributed Epipe service between
ALA-1 and ALA-2.
*A:ALA-1>config>service>epipe# info
----------------------------------------------
description "Distributed Epipe service to east coast"
sap 5/1/2:0 create
To Next Page
Loading...
