Virtual Leased Line Services
7750 SR OS Services Guide Page 159
filter
Associates an IP filter policy with an ingress or egress Service
Distribution Point (SDP).
249
vc-label
Configures the egress or ingress VC label. 272
precedence
Specifies the precedence of this SDP bind when there are multiple
SDP binds attached to one service endpoint.
128
no shutdown
Administratively enables the spoke SDP binding 233
Configure endpoint parameters
config>service>apipe
config>service>epipe
config>service>fpipe
config>service>ipipe
endpoint
Specifies a service endpoint. 238
active-hold-delay
Specifies that the node will delay sending the change in the T-LDP
status bits for the VLL endpoint when the MC-LAG transitions the
LAG subgroup which hosts the SAP for this VLL endpoint from
"active" to "standby" or when any object in the endpoint.
238
description
Specifies a text string describing the endpoint. 233
revert-time
Configures the time to wait before reverting back to the primary spoke
SDP defined on this service endpoint, after having failed over to a
backup spoke SDP.
239
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
