Alcatel-Lucent 7750 SR OS - Page 158

Configuring a VLL Service with CLI
Page 158 7750 SR OS Services Guide
rate
Specifies attributes of the Peak Information Rate (PIR) and the
Committed Information Rate (CIR) parameters.
258
scheduler-override
Specifies attributes of the the set of attributes whose values have been
overridden via management on this virtual scheduler.
259
scheduler-policy
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
262
Configure Ipipe SAP ingress parameters
config>service>ipipe>sap#
ingress
Configures ingress SAP QoS policies and filter policies. 249
filter
Associates an IP filter policy or MAC filter policy with an ingress
SAP or IP interface.
249
match-qinq-dot1p
Configures filtering based on the p-bits in the top or bottom tag of a
Q-in-Q encapsulated Ethernet frame.
263
qos
Associates a Quality of Service (QoS) policy with an ingress SAP or
IP interface.
251
queue-override
Enables the context to configure override values for the specified SAP
egress QoS queue.
252
queue
Specifies the ID of the queue whose parameters are to be overridden. 252
adaptation-rule
Specifies attributes of the queue’s adaptation rule parameters. 253
cbs
Specifies attributes of the CBS parameters. 255
high-prio-only
Specifies attributes of the high-prio-only parameters. 256
mbs
Specifies attributes of the MBS parameters. 257
rate
Specifies attributes of the Peak Information Rate (PIR) and the
Committed Information Rate (CIR) parameters.
258
scheduler-override
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
259
scheduler-policy
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
259
Configure Ipipe spoke SDP parameters
config>service>ipipe# spoke-sdp sdp-id:vc-id [no-endpoint]
config>service>ipipe# spoke-sdp sdp-id:vc-id [endpoint endpoint-name] [icb]
ce-address
Specifies the IP address of the CE device associated with an Ipipe
spoke SDP.
276
control-word
Specifies whether the use of the control word is preferred or not.
127
egress
Configures the egress spoke SDP context. 271
ingress
Configures the ingress spoke SDP context. 249
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command Description Page