Mirror Services
7750 SR OS Services Guide Page 1313
List of Commands
Table 41 lists all the configuration commands to configure mirroring parameters, indicating the
configuration level at which each command is implemented with a short command description.
The command list is organized in the following task-oriented manner:
• Configure mirror destination parameters
• Configure mirror source parameters
• Configure an SDP
Table 1: CLI Commands to Configure Mirroring Parameters
Command Description Page
Configure mirror destination parameters
config>mirror
mirror-dest
Creates a context for configuring a packet mirroring service. The mirroring
instance is set up like a service to allow the mirrored packets to be directed
over the core of the network and have a far end 7750 SR decode the mirror
encapsulation.
1346
service-id
A unique service identification value which identifies this service in the
service domain.
1347
description
A text description providing details of the mirroring instance. 1343
sap
Creates a Service Access Point (SAP) within a mirror destination service. A
sniffer can be attached to this port.
1348
sdp
Binds an existing Service Distribution Point (SDP) to the mirror destination
service ID. SDPs are used only for remote mirroring.
1351
remote-source
The context to configure remote devices allowed to mirror traffic to this
device for mirror service egress.
1347
fc
Specifies a forwarding class for all mirrored packets transmitted to the
destination SAP or SDP overriding the default forwarding class. All packets
are sent with the same class of service to minimize out of sequence issues.
1346
far-end
Defines a remote source 7750 SR that may send mirrored packets to this
7750 SR for handling by the mirror destination service ID.
1345
egress
Configure SAP egress policies. 1351
qos
Configure an egress QoS policy for the SAP. 1351
To Next Page
Loading...
