List of Commands
Page 1314 7750 SR OS Services Guide
slice-size
Enables mirrored frame truncation and configures the maximum portion of
the mirrored frame that will be transmitted to the mirror destination.
1353
no shutdown
Administratively enables the mirroring instance. 1343
Configure mirror source parameters
debug>mirror
mirror-source
Configures packet mirroring match criteria for a mirror service. This
configuration is not saved.
1357
service-id
This is the mirror service ID which identifies the service. This service must
be created first in the mirror destination context.
1357
port
Enables mirroring of traffic ingressing or egressing a port (Ethernet port,
SONET/SDH or TDM channel, Link Aggregation Group (LAG)).
1358
sap
Enables mirroring of traffic ingressing or egressing a SAP. 1359
ip-filter
Enables mirroring of packets matching specific filter entries in an IP filter. 1354
ingress-label
Enables mirroring of ingress MPLS frames based on the top-of-stack MPLS
label. Multiple labels can be defined simultaneously. The ingress label must
be active in the source router.
1354
mac-filter
Enables mirroring of packets matching specific filter entries in a MAC filter. 1356
no shutdown
Administratively enables the instance for source mirroring. 1343
Configure an SDP
config>service
sdp
Creates a Service Distribution Point (SDP). 90
far-end
Configures the system IP address of the far-end destination 7750 SR for the
SDP that is terminating services.
93
lsp
Creates associations between one or more label switched paths (LSPs) and
an MPLS SDP. LSPs are configured in the
config>router>mpls context.
94
path-mtu
Configures the Maximum Transmission Unit (MTU) in bytes that the SDP
can transmit to the far-end 7750 SR without packet dropping the SDP-type
default path-mtu.
96
no shutdown
Administratively enables the SDP. 79
keep-alive
Configures SDP connectivity monitoring keepalive messages for the SDP
ID.
97
hello-time
Configures the time period between SDP keepalive messages on the SDP-ID
for the SDP connectivity monitoring messages.
98
Table 1: CLI Commands to Configure Mirroring Parameters (Continued)
Command Description Page
To Next Page
Loading...
